Gana Fill PLLA X Body Set

Reconstitute with 18ml of sterile water for injections 
One vial contains Injectable PLLA 1560mg 

40CC of Hyaluronic Acid

Made in Korea 

Gana Fill X contains poly-L-lactic acid, which is a biocompatible, biodegradable substance that is gradually and naturally absorbed by the body and commonly found in dissolvable stitches. Gana Fill injectable that helps gradually replace lost collagen — an underlying cause of facial aging — for results that can last more than two years.

As a poly-L-lactic acid (PLLA) collagen stimulator, Gana Fill is different from typical dermal fillers such as hyaluronic acid. Poly(L-lactide) is a biodegradable material with good bio-absorbability and bio-compatibility. After degradation in the body, PLLA products are excreted by metabolism and thus has no harmful side effects to the human body. It works with your body within the deep dermis, rather than topically, to help revitalize collagen production and help restore your skin’s inner structure and volume.1-3 As the PLLA microparticles are absorbed, they help stimulate collagen production. Rebuilt collagen strands begin gradually helping to restore facial volume4 and the look of fullness to wrinkles and folds.

GANA FILL PROCEDURE

1.Reconstitute with 18ml of sterile water at least 1hours before injection.
2.If you use vortex mixer ,dissolution time will be under 60 seconds.
3.Use blunt needle larger than 21G.
4.For subcutaneous injection. For better performance inject deeper.
5.Use fan technique and avoid injecting too much in one area.
6.Do not use for forehead, lips, nose or areas near the eyes.
7.Use for face, breast and hip volume augmentation and acne scar recovery.
8.Effects can be seen 4 weeks after treatment up until 8 weeks after treatment. Volume augmentation lasts for 2 years.
9.Vigorous massaging is necessary around the area of treatment for 30 minutes every day for the first week
10.Two or three session is needed

Precaution
1.Do not treatment prohibited area.(lip, nose, forehead)
2.Use distilled water only. (Do not use a saline solution or water.)
3.Don't inject at one spot too much , inject widely and deeply to avoid granuloma formation
4.Patient have to get second treatment.(Check progress)

First session
Temporal area
-2V max
Nasolabial fold
-2V max
Cheek
-4V max
Ant zygomatic area
-2V max

Second session
One month later
-half dose of first session

Depth of injection
-Subcutaneous layer or periosteum

Injection technique
-Fan technique using canula